Advertisement
INSTALLATION INSTRUCTION FOR
CMAX-OUS1-UW-I53 AND CMAX-OUS1-UW43-I53
Method 1:
Installation Steps
1) Cut a hole in the ceiling tile with the diameter shown above.
2) Remove the retaining nut from the back of the antenna.
3) Feed these two pigtails of this antenna through the hole in the ceiling tile.
4) Re-install the retaining nut so that it is close-fitting to the ceiling tile.
Method 2:
Technical Support:
M0153A8A_InstInstr_CMAX-OUS1-UWxx-i53
http://www.commscope.com/wisupport
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for CommScope CMAX-OUS1-UW-I53
Summary of Contents for CommScope CMAX-OUS1-UW-I53
- Page 1 INSTALLATION INSTRUCTION FOR CMAX-OUS1-UW-I53 AND CMAX-OUS1-UW43-I53 Method 1: Installation Steps 1) Cut a hole in the ceiling tile with the diameter shown above. 2) Remove the retaining nut from the back of the antenna. 3) Feed these two pigtails of this antenna through the hole in the ceiling tile.
- Page 2 © Copyright 2020 CommScope, Inc. All rights reserved. All information contained in this manual has been revised thoroughly. Yet CommScope accepts no liability for any omissions or faults. CommScope reserves the right to change all hardware and software characteristics without notice.
Need help?
Do you have a question about the CMAX-OUS1-UW-I53 and is the answer not in the manual?
Questions and answers