Installing The Outdoor System; Installing The Outdoor Caller Unit - hager LCP01X User Manual

5. Installing the outdoor system

5.1 Installing the outdoor caller unit

IMPORTANT: to ensure the outdoor caller unit remains watertight, never try to open it!
1. To ensure easy use, fix the unit at a height
of 1.20 m.
Please refer to the next chapter for mounting outdoor caller units with armoured cover.
Follow steps 3 to 6 below for units without armoured cover.
3. If the cable goes around the pillar, pierce
one of the cable knock-outs with a cutter.
5. Thread the cable through the
hole knocked out in step 3
and screw the caller unit
in place. Put the screw
covers back.
Pozidriv 2
1.20 m
2. Mark and drill the outdoor caller unit holes
with a Ø 6 mm drill bit. Also mark the
place where the cable feed hole has to be
drilled (Ø 8 mm min. recommended).
4. Push the screw covers out using a flat
screwdriver.
3.5
6. Use a pencil or
permanent marker
to write the names.
Stick a transparent
protection label on
top.
TIP: you can print the
labels using the
software (EtikPrint)
available on the Hager
web site.
189
G