G
4.2 Charging the handset before installation
IMPORTANT: when installing the system, the handset(s) must be charged on the base before it/they can be
used.
1. Open the base.
3. Rotate the back of the base until it is in "table" position.
4. Thread the power pack jack through the
hole.
IMPORTANT: only MHU01X or MHU01U power
packs supplied must be used.
2. Remove the 4 anti-slip pads.
5. Connect the jack to the base making sure
that the cable is positioned in the
designated slot.
Thread the cable
through here
186
Alternative cable
passage