VeEX OTDR FX150+ Series User Manual page 27

You can activate the Touchscreen Calibration Mode using the keypad by
pressing SAVE + HOME keys simultaneously for 3 seconds, then releasing.
Press SAVE + HOME again to start a new calibration.
• Backlight: User defined settings when unit is used on Battery or AC power including
Brightness settings. To help improve the battery autonomy and preserved LCD life,
configure the timer to turn off the backlight if the unit is not in use and adjust the
duration of the idle time. Once the timer is active and the backlight is turned off, any
action on the test set (touch screen, keypad) will turn on the backlight again.
• Global: Various settings including:
General Settings
• Language: English, German, French, Chinese, Japanese, Korean and others (de-
pends on software version). You must reboot the device to fully activate the new
language.
• Units: Measurement system (English - feet or Metric - meter).
• Audible Alarm: When enabled, the test set will sound (beep) when alarms and
errors are detected or when battery runs low.
• Show Password: Shows/Hides username and password associated with FTP and
related IP functions.
• User Interface: The USA user interface version presents SONET/DSn application-
oriented menus, while the International setting is open to all settings.
• WiFi Auto Connect: After successfully connecting to a WiFi access port, the unit
will attempt to connect automatically to the same AP after the unit is turned off and
then turned back on.
• RTU-410 (OTDR) Emulation Mode: Enables remote control of the FX150 OTDR
using API commands.
• OTG Port Mode: Configures the micro USB port for any USB device connected via
an OTG cable. Later models will detect and configure automatically the OTG port to
host or device mode.
OTDR Series e-Manual, D07-00-076P-RevD00
Activating Touchscreen Calibration Mode
Page 27 of 109