First Use; Using The Cooktop - Smeg Linea PX7502AU Manual

3.2 First use

1. Remove any protective film from the
outside or inside of the appliance,
including accessories.
2. Remove any labels (apart from the
technical data plate) from accessories.
3. Remove and wash all the appliance's
accessories (see 4 Cleaning and
maintenance).

3.3 Using the cooktop

All the appliance's control and monitoring
devices are located together on the front
panel. The burner controlled by each knob
is shown next to the knob. The appliance is
equipped with an electronic ignition device.
Simply press the knob and turn it anti-
clockwise to the maximum flame symbol,
until the burner ignites. If the burner does not
light in the first 15 seconds, turn the knob
to and wait 60 seconds before trying
again. After lighting, keep the knob pressed
in for a few seconds to allow the
thermocouple to heat up. The burner may
go out when the knob is released: In this
case, the thermocouple has not heated up
sufficiently. Wait a few moments and repeat
the operation. Keep the knob pressed in
longer.
In case of an accidental switching
off, a safety device will be tripped,
cutting off the gas supply, even if
the gas tap is open. Return the
knob to
60 seconds before lighting it
again.
and wait at least
Use
Correct positioning of the flame-
spreader crowns and burner caps
Before lighting the cooktop burners, make
sure that the notches of the flame-spreader
crowns (A) are positioned in their
corresponding housings (B) with their
respective burner caps. Make sure that the
holes in the burner (C) are aligned with the
igniters and thermocouples (D). Also ensure
that the flame-spreader crowns are
correctly engaged in the burner holes.
13