Table of Contents
Advertisement
Quick Links
These instructions apply only to the destination countries listed on the appliance's data
plate.
This is a class 3 built-in hob.
We advise you to read this manual carefully, as it contains all the instructions for maintaining
the appliance's aesthetic and functional qualities.
For further information on the product: www.smeg.com
Contents
4
4
7
7
8
8
8
9
10
10
11
12
12
13
13
16
16
16
18
18
19
20
21
23
23
26
29
30
3
Advertisement
Table of Contents
Related Manuals for Smeg Linea PX7502AU
Summary of Contents for Smeg Linea PX7502AU
-
Page 1: Table Of Contents
These instructions apply only to the destination countries listed on the appliance's data plate. This is a class 3 built-in hob. We advise you to read this manual carefully, as it contains all the instructions for maintaining the appliance’s aesthetic and functional qualities. For further information on the product: www.smeg.com... -
Page 2: Instructions
Instructions 1 Instructions • Make sure that the flame-spreader crowns are correctly positioned in 1.1 General safety instructions their housings with their respective burner caps. Risk of personal injury • Be aware of how rapidly the • During use the appliance and its cooking zones heat up. - Page 3 Instructions • Switch the appliance off • Never leave the appliance immediately after use. unattended during cooking operations in which fats or oils • DO NOT MODIFY THIS could be released that could APPLIANCE. overheat and catch fire. Be very •...
- Page 4 Instructions • Do not use cleaning products • Installation with flexible hose must containing chlorine, ammonia or be carried out so that the length of bleach on steel parts or parts with the piping does not exceed 2 metres metallic surface finishes (e.g. when fully extended as regards anodizing, nickel- or chromium- flexible steel hoses and 1.5 metres...
-
Page 5: Manufacturer Liability
Instructions • The settings for this domestic Manufacturer liability appliance are shown on the gas The manufacturer declines all liability setting label. for damage to persons or property • This domestic appliance is not caused by: connected to a device for •... -
Page 6: Disposal
Instructions 1.4 Disposal Our appliances are packaged in non-polluting and recyclable This appliance must be materials. disposed of separately from • Deliver the packing materials to other waste (Directives the appropriate recycling centre. 2002/95/EC, 2002/96/EC, 2003/108/EC). The appliance Plastic packaging does not contain substances in Danger of suffocation quantities sufficient to be considered... -
Page 7: How To Read The User Manual
Instructions 1.7 How to read the user manual This user manual uses the following reading conventions: Instructions General information on this user manual, on safety and final disposal. Description Description of the appliance and its accessories. Information on the use of the appliance and its accessories. -
Page 8: Description
Description 2 Description 2.1 General Description AUX: Auxiliary burner SR: Semi-rapid burner R: Rapid burner UR3: Ultra-rapid burner... -
Page 9: Symbols
Description 2.2 Symbols Burners Burner off Burner at minimum setting Burner at maximum setting Cooking zones Front left Rear left Central Rear left Front right Burner knobs For lighting and adjusting the burners. Press and turn the knobs anti-clockwise to order to light the relative burners. -
Page 10: Use
3 Use Escaping gas may cause an explosion. If you smell gas or notice any faults in the 3.1 Instructions gas installation: • Immediately shut off the gas supply or Improper use close the gas cylinder valve. Danger of burns •... -
Page 11: First Use
3.2 First use Correct positioning of the flame- spreader crowns and burner caps 1. Remove any protective film from the outside or inside of the appliance, Before lighting the cooktop burners, make including accessories. sure that the notches of the flame-spreader crowns (A) are positioned in their 2. - Page 12 Correct positioning of the trivets Installing the trivets There are concave silicone rests with a hole The trivets are provided unassembled on underneath the trivets that must be the cooktop. To position each trivet positioned on the relative fixing pins on the correctly on its burner, follow the instructions cooktop.
- Page 13 Practical tips for using the cooktop Using a griddle For better burner efficiency and to minimise gas consumption, use lidded pans of suitable size for the burner, so that flames do not reach up the sides of the pan. Once the contents come to the boil, turn down the flame enough to ensure that the liquid does not boil over.
-
Page 14: Cleaning And Maintenance
Cleaning and maintenance 4 Cleaning and maintenance Food stains or residues Do not use steel sponges and sharp 4.1 Instructions scrapers, as they will damage the surfaces. Use normal, non-abrasive products and a Improper use wooden or plastic tool, if necessary. Rinse Risk of damage to surfaces thoroughly and dry with a soft cloth or a microfibre cloth. - Page 15 Cleaning and maintenance Igniters and thermocouples Knobs For correct operation the igniters and Do not use aggressive products thermocouples must always be perfectly containing alcohol or products for clean. Check them frequently and clean cleaning steel and glass when them with a damp cloth if necessary. cleaning the knobs, as these Remove any dry residues with a wooden products could cause permanent...
-
Page 16: Installation
Installation 5 Installation 5.1 Clearances above and around domestic appliances This appliance must be installed by an highest part of the hob shall be protected authorised person in accordance with this for the full width and depth of the instruction manual, AS/NZS 5601.1 – cooking surface area in accordance Gas installations (installation and pipe with Clause 5.12.1.2. -
Page 17: Safety Instructions
Installation 3. Additional requirements for Free- 5.2 Safety instructions standing and Elevated Cooking Heat production during appliance Appliances – (Measurements D & E) operation Where D, the distance from the Risk of fire periphery of the nearest burner to a horizontal combustible surface is less •... -
Page 18: Section Cut From The Work Surface
Installation 5.3 Section cut from the work surface Overall dimensions: gas and electrical connection location (measures in mm) The following operation requires building and/or carpentry work and must therefore be carried out by a competent tradesman. Installation can be carried out on various materials such as masonry, metal, solid wood or plastic laminated wood as long as they... -
Page 19: Mounting
Installation 5.4 Mounting Over empty kitchen unit or drawers If there are other pieces of furniture (lateral Over built-in oven unit walls, drawers, etc.), dishwashers or fridges The clearance between the cooktop and under the cooktop, a double-layer wooden the kitchen furniture or other installed base must be installed at least 10 mm from appliances must be enough to ensure the bottom of the cooktop to avoid any... - Page 20 Installation Cooktop seal 4. Install the appliance by resting the cooktop frame completely on the back To prevent leakage of liquid between the edge of the hole in the countertop (1) frame of the cooktop and the work surface, and then lower the front (2) until it is fully put the insulating seal provided in position inserted.
-
Page 21: Fixing Using Brackets
Installation 5.5 Fixing using brackets 5.6 Gas connection The figures below show the exact position Gas leak of the holes to correctly attach the cooktop Danger of explosion to the countertop using the brackets provided (A) • After carrying out any operation, check that the tightening torque of gas connections is between 10 Nm and 15 Nm. - Page 22 Installation Connection of the appliance to the gas To check the operating pressure of the supply must be in accordance with the appliance it is recommended at least 2 requirements of AS5601. A ½” BSP large size burners are used. Ensure connector at the inlet is recommended and appliance is secured to wall when the gas supply line to the appliance must be...
- Page 23 Installation Connection to liquid gas Extraction of the combustion products Use a pressure regulator and make the This domestic appliance is not connection on the gas cylinder following connected to a device for the guidelines set out in the regulations in extracting combustion products.
-
Page 24: Adaptation To Different Types Of Gas
Installation 1 Extraction using a hood 2. Remove the flame-spreader crowns and relative burner caps. 2 Extraction without a hood A Single natural draught chimney B Single chimney with extractor fan C Directly outdoors with wall- or window- mounted extractor fan D Directly outdoors through wall Combustion products Extractor fan... - Page 25 Installation 4. Unscrew the cooktop fastening screws Replacing injectors and primary air adjustment and the burner support plates. 5. Remove the casing fastening screws. 1. Loosen the screw A and push the air regulator B all the way down. 6. Remove the top. 2.
- Page 26 Installation Adjusting the minimum setting for natural Adjusting the minimum setting for LPG • Tighten the screw located at the side of Light the burner and turn it to the minimum the tap rod clockwise all the way. position. Extract the gas valve knob and turn Following adjustment to a gas the adjustment screw next to the valve other than the one originally set in...
-
Page 27: Electrical Connection
Installation Burner and injector specifications tables NG 1.0 kPA Nominal gas consumption (MJ/h) 10.8 14.6 Injector (1/100 mm) Primary air (mm) ULPG 2.75 kPa Rated heating capacity (MJ/h) 10.4 15.1 injector diameter (1/100 mm) Primary air (mm) The injectors not provided are available at Authorised Service Centres. 5.8 Electrical connection General information Check the grid characteristics against the... -
Page 28: Instructions For The Installer
Installation 5.9 Instructions for the installer Fixed connection • The plug must be accessible after Fit the power line with an omnipolar circuit installation. Do not bend or trap the breaker in compliance with installation power cable. regulations. The circuit breaker should be located near •...