Table of Contents
Advertisement
6> Select "Configure Boot Devices" to display the Boot device's settings window.
01: LPe1250-F8-N : Bus#: 30 Dev#: 00 Func#: 00
Mem Base: E7B40000 Firmware Version : OS2.01A12 Boot BIOS: Disabled!
Port Name: 10000090FA21128 Node Name: 20000090FA21128
Topology: Auto Topology: Loop First (Default)
1. Unused DID:000000 WWPN:00000000 00000000 LUN:00 Primary Boot
2. Unused DID:000000 WWPN:00000000 00000000 LUN:00
3. Unused DID:000000 WWPN:00000000 00000000 LUN:00
4. Unused DID:000000 WWPN:00000000 00000000 LUN:00
5. Unused DID:000000 WWPN:00000000 00000000 LUN:00
6. Unused DID:000000 WWPN:00000000 00000000 LUN:00
7. Unused DID:000000 WWPN:00000000 00000000 LUN:00
8. Unused DID:000000 WWPN:00000000 00000000 LUN:00
Notice
7> Select an entry number to register the Boot device. Then, you see the window to select a device.
01: LPe1250-F8-N : Bus#: 30 Dev#: 00 Func#: 00
Mem Base: E7B40000 Firmware Version : OS2.01A12 Boot BIOS: Disabled!
Port Name: 10000090FA21128 Node Name: 20000090FA21128
Topology: Auto Topology: Loop First (Default)
00. Clear selected boot entry!!
01. ALPA:B3(7D) WWPN:21000016 97122446 LUN:00 NEC DISK ARRAY 1000
Emulex LightPulse FC BIOS Utility. OB2.12a15
List of saved Boot Devices:
<↑/↓> to Highlight, <Enter> to Select
Copyright (c) 1997-2014 Emulex. All rights reserved.
If no Boot device can be detected from this product you selected above, you will
see a message, "This Adapter is not ready, try again!" If you selected a wrong
number in the above step, press <Esc> key to return to the previous window and
select the correct one.
If you have selected the correct figure, confirm that the Fibre Channel device is
properly connected and its settings are all correct. Then, reboot the computer
and try these steps from the beginning.
Emulex LightPulse FC BIOS Utility. OB2.12a15
Enter <Esc> to exit <PageDn> to Next Page
<↑/↓> to Highlight, <Enter> to Select
Copyright (c) 1997-2014 Emulex. All rights reserved.
- 66 -
Advertisement
Table of Contents
