Hardware Reset - Vivotek IZ7151 User Manual

VIVOTEK

Hardware Reset

There is an indented reset button on the back panel of the Network Camera� It is used to reboot
the Network Camera or restore the Network Camera to factory default� Sometimes rebooting the
Network Camera sets the Network Camera back to normal state� If the problems remain after
rebooting, restore the factory default and install again�
Press and release the indented reset button with a needle� Wait for the Network Camera
Reboot :
to reboot�
Press the indented reset button continuously for around 30 seconds until the status LED
Restore :
rapidly blinks red and green simultaneously� Note that all settings will be restored to factory default�
6 - User's Manual
Audio
Out
Ethernet
1 2 3 4 5 6 7 8
RESET
Mic Ext. Int. Audio
Out
Ethernet
1 2 3 4 5 6 7 8
RESET