Table of Contents
Advertisement
4. SERVICE PROCEDURES
(G) Confirm and change the indoor unit address
The purpose of the above function is to let you confirm the indoor unit address
after the auto. address operation, and change the indoor unit address if it is
needed.
a Press the TEST / CHK and
seconds.
AIR FLOW
UNIT
FLAP
TIMER SET
SET
CL
b Select the R.C. No. which you want to change with the UNIT (up) or
FLAP (down) buttons.
c Press the SET button (to confirm the R.C. No.).
The smallest registered indoor No. and the selected R.C. No. will be
displayed.
AIR FLOW
UNIT
FLAP
TIMER SET
SET
CL
d Select the indoor No. which you want to change with UNIT button. Once in this mode,
the fan motor of selected indoor unit will turn on and let you confirm the indoor
unit address.
(
) buttons at the same time for more than 4
MODE
R.C.
SET TEMP.
CODE
No.
FAN SPEED
SETTING
SET DATA
ON
•
OFF
•
TEST / CHK
0362_M_I
MODE
UNIT No.
R.C.
No.
SET TEMP.
CODE
No.
FAN SPEED
SETTING
SET
DATA
ON
•
OFF
•
TEST / CHK
0363_M_I
Ex:
R.C. No. 3 is selected.
Indoor No. 2 is the smallest indoor No. of
the R.C. No. 3.
90
–
–
4
Advertisement
Table of Contents
