Lighting Instructions; Appliance Break-In - Vermont Castings OD30CFLN/P Installation And Operation Instructions For

Hide thumbs

Table Of Contents

Table of Contents

WARNING: If you do not follow these directions exactly, a ﬁre or explosion may result caus-

ing property damage, personal injury, or loss of life.

• Do not try to light any appliance.

• Do not touch any electrical switch, do not use any phone in the immediate area.

• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

• If you cannot reach your gas supplier, call the ﬁre department.

1. Turn the gas shut-off valve to OFF.

2. Wait ﬁve (5) minutes to clear out any gas. If you then smell gas STOP!

Follow the safety information above. If you don't smell gas, go on to the

next step.

3. Light a match and lay it on top of the pan material, about 2" from the

end of the supply side of the pan (Fig. 16).

4. Slowly turn the gas shut-off valve ON until the burner ignites. If the

burner doesn't ignite within ten (10) seconds with the match burning,

turn the shut-off valve OFF and repeat steps 1 through 4 again.

WARNING: Flame may ﬂare up when ignited. Keep hands and face away from ﬁrebox.

To Adjust the Flame:

Adjust the ﬂame to the desired level by rotating the gas valve counterclockwise

clockwise

to close.

To Turn the Appliance Off:

Rotate the gas shut-off valve clockwise

Proper Maintenance:

• Keep the area around the log set clean and clear of debris.

• Occasionally, you may use a soft bristle brush to clean logs.

• Once every year, a qualiﬁed agency or certiﬁed chimney sweep should examine and clean the venting

system of the ﬁreplace in which the log set is installed.

During the 2-3 hour appliance break-in period, you may detect an odor from the appliance as the various

water-based paints used in the manufacture of this log set cure. This is a normal and temporary situation

that is not a cause for alarm.

To ensure proper curing of the logs:

1. Ignite a 2" ﬂame and maintain it for 1/2 hour.

2. Burn the logs in consecutive 1/2 hour periods, raising the ﬂame an additional 2" to full ﬂame height for a

total of three hours.

20004180

For Your Safety Read Before Lighting

What To Do If You Smell Gas