Millivolt/Thermostat Control Lighting Instructions; To Turn Off Gas To Heater - Vermont Castings VFC24C Installation & Operating Instructions Manual

Vfc vent free fireplace system
Table of Contents

Advertisement

VFC Vent Free Fireplace System
MILLIVOLT/THERMOSTAT CONTROL
1. STOP! Read the safety information label.
2. Make sure the manual shutoff valve is fully open.
3. This gas log set is equipped with an ignition device (piezo) which automatically lights the pilot. If piezo
ignitor does not light the pilot, refer to instructions for Match Lighting Instructions on the following page.
4. Turn gas control knob clockwise
5. Wait (5) minutes to clear out any gas. Then smell for gas, including near the fl oor. If you smell gas,
STOP! Follow "B" in the safety information label. If you don't smell gas, go to next step.
6. From OFF position, turn the gas control knob counterclockwise
knob for 5 seconds. NOTE: If you are running the heater for the fi rst time, it will be necessary to
press in the control knob for 30 seconds to allow air to bleed out of the gas piping.
7. With the control knob pushed in, push in and release the piezo ignitor button to light the pilot.
8. Continue pushing the control knob in for a further 60 seconds to prevent the fl ame detector from shut-
ting off the gas while the probe is warming up. Release the control knob.
9. Turn gas control knob counterclockwise
10. After the pilot has been lit for one minute, the burners can be turned on. Turn the ON/OFF switch to
ON position or adjust thermostat to desired setting.
11. If the gas logs will not operate, follow the instructions "To Turn Off Gas To Appliance" below and call
your service technician or gas supplier.
Pilot
1. Turn control knob clockwise
2. If applicable: Turn ON/OFF switch to OFF position and/or set thermostat (if present) to lowest setting.
3. If applicable: Turn off all electric power to the heater.
30
LIGHTING INSTRUCTIONS
to the OFF position and turn ON/OFF switch to OFF position.
On/Off Switch

TO TURN OFF GAS TO HEATER

to OFF position to completely shut off the heater.
to the ON position.
Piezo Ignitor
Control Knobs
Millivolt Controls
OPERATING INSTRUCTIONS
to IGN position. Push in control
Blower Control
20308011

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vfc24lVfc32cVfc32l

Table of Contents