Vermont Castings OD30CFLN/P Installation And Operation Instructions For page 7

Grate Assembly
1. Place the grate steps onto the back of the
grate as shown in Figure 7.
2. Place grate assembly over top of burner so
that the front two middle legs of grate are resting
against the front portion of the main burner area.
(Fig. 7)
3. If the retaining bracket on the rear bottom feet
of the grate were removed for pan installation,
replace them now.
Grate Steps
Grate
(ODSHR42,
20002230)
Main
Burner
Front
Ember Pan
Fig. 7 Grate assembly.
Add Pan Material
1. With burner pan and grate in place, open the
bag of lava rock and spread it evenly across the
pan assembly to the top of the pan assembly. (Fig.
8)
2. Open one bag of glowing embers and place
evenly across burner covering lava rock. (Fig. 9)
3. Slide the mesh screen under the grate, but on
top of glowing embers so the mesh piece covers
the burner pan material. (Fig. 10)
4. Open remaining bag of embers and place
evenly on top of mesh screen. (Fig. 10)
5. Spread lava rock onto fireplace hearth around
the burner pan for decorative purposes. (Fig. 11)
20004180
Grate Placement
FP1144
FP1144
Grate Assy
8/13/01 djt
Lava Rock
FP1145
Fig. 8 Lava rock placement.
Glowing Embers
Fig. 9 Ember placement.
Embers
FP1147
Fig. 10 Screen and ember placement.
Lava Rock
Fig. 11 Place lava rock on fireplace hearth for decoration.
Pan
Assembly
FP1145
OD30 lava rock
8/13/01 djt
FP1146
OD30 embers
8/13/01 djt
Ember Screen
FP1147
OD30
Screen & embers
8/13/01 djt
FP1146
FP1148
7