Vermont Castings OD30CFLN/P Installation And Operation Instructions For page 5

NOTE: This is for burner connection purposes only. Ex-
act burner placement will be covered on Page 7, after
all connections have been made.
3. Attach the Gas Supply Fitting onto your fireplace's
gas supply pipe, as shown in Figure 2.
4. Attach one end of the Flexible Gas Connector to
the brass Burner Inlet Fitting which has been factory
installed into the burner.
5. Attach the other end of the Gas Connector to the
flared side of the Gas Supply Fitting.
Remember to use pipe thread sealant or teflon tape
only on the straight pipe threads. Do not use on
any flared ends.
NOTE: Your gas log set is assembled at the factory to be installed in a fireplace plumbed with the gas on
the right side (facing). If your fireplace is plumbed with the gas on the left side remove fittings on right and
left side of straight burner tube and switch sides, at the same time put front burner tube on right side with
the elbow fitting (Refer to Figs. 3,4).
You may also run a flexible connector (or as per local codes) along the back wall of the fireplace to bring
your gas line to the right hand side. You can then place the set in front of the flexible connector (Fig. 4).
Fig. 3 LP gas connection.
Fig. 4 Alternate left side gas connection.
20004180
Gas Plumbed On Left Hand Side Of Fireplace
Regulator
Supplied w/LP Unit
3/8" Brass Elbow
NPT to Flare
FP1143
OD30CFL
LP hook up
8/10/01 djt
CFM159
CFM159
R-CFL Gas Supply Connection
2/14/01 sta
Fig. 2 Natural gas connection.
CFM149
R-CFL Gas Supply Connection
2/14/01 sta
Rigid Pipe. Flexible Hose or Copper Tubing
Approved for Outdoor Use
Gas Inlet 3/8"
Pipe Coupling
Flex Hose
To Gas Supply
Parts Not
Supplied
CFM150
CFM149
FP1143
CFM150
5