Disassembly Procedure For Indoor Unit; Removing Air Intake Grille - Technibel GRV79R5VAA Technical Data & Service Manual

12. DISASSEMBLY PROCEDURE FOR INDOOR UNIT

IMPORTANT! Please Read Before Starting
Safety precautions for servicing the CEILING-MOUNTED indoor unit
Before attempting to replace heavy and bulky parts such as the evaporator and fan motor, disconnect the
indoor unit from the system and place it on the floor. Refer to the steps given below.
When checking or servicing the air intake grille, side panels, or electrical component box, first check that
power is completely disconnected. Pay utmost care that your working platform is stable enough. Also, do not
drop any replaced parts and tools on the floor.
For Floor Installation

12-1. Removing Air Intake Grille

(1) Hold both ends and pull forward to open the
air intake grille. (Fig. 1)
(2) Remove the metal clips connecting the unit and the
grille. First, with a screwdriver, loosen
the * marked screw a little at the right side clip
(DO NOT loosen it too much, otherwise, the screw
and small metal parts will fall off inside.), then press
on the stopper and pull off. (Fig. 2)
(3) Do the same procedure for the left metal clip.
(4) Unlatch the 2 tabs on the lower part of the grille to
take it off completely.
Metal clip
70
Air intake grille
Center latch
Unit
Air intake
grille
*
Fig.1
Fig.2