Addenda A: Summary Of Quick Operating - Baudcom BD-FS-30 User Manual

Addenda A: Summary of quick operating

I. Preparing
1. Verify that the machine is plugged in power or the battery capacity is
enough; then press
2. In the standby mode, press
the cursor to [Operation Options]; press
[pause 1],[pause 2] respectively as "ON","OFF","OFF".
Discharge Calibration
3.
Discharge calibration is needed because constant changing of
atmospheric conditions such as temperature and pressure, and the
long service of the machine creates variability in the arc temperature
and position.
Step of discharge calibration
In the [ Ready ] mode, press
Then prepare and place fiber according to the method described in
fiber preparation. Close the wind protector. Press
Calibration]. Discharge calibration automatically starts. The user is
recommended to repeatedly prepare and place fiber in discharge
calibration interface, until the "Step II of discharge calibration
completed" message is displayed for three times.
Discharge calibration is needed only arc power fluctuates strongly;
Note:*
it is not necessary upon boot every time. After discharge
calibration is completed, the machine will adjust the arc discharge
Website: www.baudcom.com.cn
and hold the key until the machine is booted.
to enter "Splice Menu" menu. Move
*
:
to enter "Splice Menu" menu.
Tel: +86 21 37709251
to enter. Set [Auto Start]
to enter [Arc
Email: info@baudcom.com.cn