Preparation Of Fiber End-Face - Baudcom BD-FS-30 User Manual

2.7 Preparation of fiber end-face

2.7.1 Open the big and small clips of the cutter; push the sliding plate
installed with blade from the end to the front.
2.7.2 Use fiber stripping pliers to strip fiber coating layer, the length of
which is 30-40 mm. Use gauze dipping with alcohol or wadding soft
enough to wipe clean the fiber. Wiping with a clean cotton cloth once,
and do not clean it with the same cloth for the second time. (Notes:
Please use the alcohol with purity more than 99 %.)
Fiber stripping
2.7.3 Aim the edge of the fiber coating layer at the "16"calibration of the
cutter yardstick and put the fiber into orientation pressure tank with
the left hand, and be sure that the bare fiber has been straightly put on
the right and left rubber pads.
2.7.4 Close the small clip, big clip by right hand and promote sliding plate
Website: www.baudcom.com.cn Tel: +86 21 37709251 Email: info@baudcom.com.cn
Clean