Table of Contents
Advertisement
4. 2 Remove the old battery
Remove the lithium battery pack from the power module of the
Fusion Splicer;
4 . 3 Place new battery pack
Aligning the card slot, place new battery into the power module and
make sure it is plugged in tightly, then close the cover of the battery
case which is at the bottom of the Fusion Splicer.
5． Power Supply
Power does not turn off when pressing
Press
and hold the key until the LED color changes from red to
green. Release
Few splices can be made with a fully charged battery pack
Website: www.baudcom.com.cn
to shut off the machine.
Tel: +86 21 37709251
Email: info@baudcom.com.cn
Advertisement
Table of Contents
