Table of Contents
Advertisement
●
If the fiber is bending, bending part should be upward when placing
the fiber.
●
To ensure the splice quality of the fiber, the clean cross-section of fiber
cannot touch other things.
2.8.3 Use fingers to pinch the fiber, and then close the left clip, and press
the fiber. Ensure the fiber is placed in the bottom of V-shape groovy.
If the fiber is placed incorrect, please replace the fiber. The fiber end
face don't touch the V-shape groove when place the fiber.
2.8.4 Place another optical fiber according to the above steps.
2.8.5 Close shielding cover.
3．Check and Maintenance
Critical cleaning points and maintenance checks are described below.
3.1 Cleaning V-grooves
If contaminants are present in the V-grooves, proper clamping may not
occur, resulting in higher splice loss. The V-grooves should be frequently
inspected and periodically cleaned during normal operation. To clean the
V-grooves do the following:
<1> Open the wind protector.
<2> Clean the bottom of the V-groove With an alcohol-impregnated thin cotton
swab. Remove excess alcohol from the V-groove with a clean dry swab.
Website: www.baudcom.com.cn
Tel: +86 21 37709251
Email: info@baudcom.com.cn
Advertisement
Table of Contents
