Installing Driver - MSI Eclipse Plus Series Manual

Installing Driver

Install Driver in Windows Vista / XP
† New Windows Vista / XP Installation
The following details the installation of the drivers while installing W indows XP.
1. W hen you start installing Windows XP and older operating systems, you may
encounter a message stating, "Setup could not determine the type of one or
more mass storage devices installed in your system". If this is the case, then
you are already in the right place and are ready to supply the driver. If this is
not the case, then press F6 when prompted at the beginning of W indows
setup.
2. Press the "S" key to select "Specify Additional Device".
3. You should be prompted to insert a floppy disk containing the JMicron RAID
driver into the A: drive.
Note: For W indows XP, you can use the USB floppy drive only.
For W indows Vista you can use CD/ DVD/ USB drive.
Important
Please follow the instruction below to make an "JMicron RAID Driver" for
yourself.
1. Insert the MSI DVD into the DVD-ROM drive.
2. Click the "Browse" on the Setup screen.
3. Copy all the contents in the \\RAID\JMicron\NoIDE\Floppy32 (for 32-bit
OS) or \\RAID\JMicron\NoIDE\Floppy64 (for 64-bit OS) to a formatted
floppy drive.
4. The driver diskette for JM icron RAID Controller is done.
4. W hen prompted, insert the floppy disk you created in step 3 and press Enter.
5. You should be shown a list of available SCSI Adapters.
6. Select the appropriate JMicron RAID controller and press ENTER.
7. The next screen should confirm that you have selected the JMicron RAID
controller. Press ENTER again to continue.
8. You have successfully installed the JMicron RAID driver, and Windows setup
should continue.
9. Leave the disk in the floppy drive until the system reboots itself. W indows
setup will need to copy the files from the floppy again after the RAID volume
is formatted, and W indows setup starts copying files.
For W indows Vista:
After selecting the location to install W indows Vista, please click on the "Load
Driver" button to install the RAID driver. Please refer the Important notice above
to make a RAID Driver medium. And then, follow the instructions to complete the
RAID drive installation and the W indows Vista installation.
JMicron RAID
E-11