MSI Eclipse Plus Series Manual page 32

TPM Module Connector: JTPM1
This connector connects to a TPM (Trusted Platform Module) module (optional). Please
refer to the TPM security platform manual for more details and usages.
2
1
JTPM 1
Pin Signal Description
1 LCLK LPC clock
3 LRST# LPC reset
5 LAD0 LPC address & data pin0
7 LAD1 LPC address & data pin1
9 LAD2 LPC address & data pin2
11 LAD3 LPC address & data pin3
13 LFRAME# LPC Frame
D-LED2 Connector: JDLED2
This connector connects to a D-LED2 (Debug-LED2) panel (optional), which shows
information on the panel for you and identify the current status or mode of the
connected system. Please refer to the D-LED2 quick guide for more details and
usages.
Chassis Intrusion Connector: JCI1
This connector connects to the chassis intrusion switch cable. If the chassis is
opened, the chassis intrusion mechanism will be activated. The system will record
this status and show a warning message on the screen. To clear the warning, you
must enter the BIOS utility and clear the record.
14
13
Pin
2
4
6
8
10
12
14
12 11
JDLED2
2 1
CINTRU
GND
JCI1
Hardware Setup
Signal Description
3V_STB 3V standby power
VCC3 3.3V power
SIRQ Serial IRQ
VCC5 5V power
KEY No pin
GND Ground
GND Ground
1
2
2-17