Answering System Settings - Panasonic KX-TG7893AZ Operating Instructions Manual

Voice guidance
During remote operation, the unit's voice
guidance starts and prompts you to press 1
to perform a specific operation, or press 2 to
listen to more available operations.
Note:
R If you do not press any dial keys within 10
seconds after a voice guidance prompt, the
unit disconnects your call.
Remote commands
You can press dial keys to access certain
answering system functions without waiting for
the voice guidance to prompt you.
Key Operation
1 Repeat message (during
*1
playback)
2 Skip message (during playback)
4 Play new messages
5 Play all messages
9 Stop playback
0 Turn answering system off
*4 Erase currently playing message
*5 Erase all messages
*# End remote operation
(or hang up)
*1 If pressed within the first 5 seconds of a
message, the previous message is
played.
Turning on the answering system
remotely
If the answering system is off, you can turn it
on remotely.
1
Dial your phone number from a
touch-tone phone.
2
Let the phone ring 15 times.
R A long beep is heard.
3
Enter your remote access code within 10
seconds after the long beep.
R The greeting message is played back.
Answering System for Landline
R You can either hang up, or enter your
remote access code again and begin
remote operation (page 60).

Answering system settings

Number of rings before the unit
answers a call
You can change the number of times the
phone rings "Ring count" before the unit
answers calls. You can select 2 to 9 rings, or
"Toll saver".
The default setting is "5 rings".
"Toll saver": The unit's answering system
answers at the end of the 2nd ring when new
messages have been recorded, or at the end
of the 5th ring when there are no new
messages. If you call your phone from outside
to listen to new messages (page 60), you
know that there are no new messages when
the phone rings for the 3rd time. You can then
hang up without being charged for the call.
Handset
1
MMENUN#211
2
MbN: Select the desired setting. a
MSAVEN a MOFFN
For service provider voice mail
subscribers (for Australia)
To receive voice mail and use the answering
system properly, please note the following:
R "Voice mail" is a service provided by your
service provider/telephone company
(page 63). You will need to first subscribe
or activate this service through your service
provider/telephone company. Contact your
service provider/telephone company on
how to operate this service and how you
will be notified that you have messages on
your voice mail.
To use this service, you will be required to
leave your answering machine off on your
unit.
This will allow the voice mail to receive any
messages.
61