Panasonic KX-TG7893AZ Operating Instructions Manual page 79

DECT repeater
Problem
The unit does not work.
While talking using the
handset, sound cuts in and out.
A repeating tone is heard while
talking using the handset.
or
The indicator continues to
light amber and the
flashes green.
Cause/solution
R When the indicators do not light, the AC adaptor is not
connected properly. Check the connections.
R When the indicators do not light green, move the unit
closer to the base unit.
R The repeater mode is "Off". Set the repeater mode to
"On" (page 68).
R Registration may have been cancelled. Deregister the
unit, then re-register.
Deregister:
1
Unplug the AC adaptor, then press and hold
MPROGRAMN.
2
While pressing and holding MPROGRAMN,
re-connect the AC adaptor.
3
Keep holding to press MPROGRAMN for about 10
seconds until the
lights red. Then release MPROGRAMN.
R The
moment then only the
R If the
MPROGRAMN, deregistration failed. Deregisterthe
unit again.
Re-register:
1
DECT repeater: Unplug the AC adaptor.
2
Base unit: Press and hold MLOCATORN for about 5
second, until the registration tone sounds.
R The next step must be completed within 90
seconds.
3
DECT repeater: Connect the AC adaptor, then wait
until the
4
Base unit: To stop the registration tone, press
MLOCATORN.
R The handset is out of range. Move the handset closer to
this unit.
R MPROGRAMN was pressed. The unit is in programming
mode. To exit, press MPROGRAMN again. Do not press
MPROGRAMN, except when deregistering the unit.
indicator
Useful Information
indicator stops flashing and
and indicators light amber for a
indicator flashes red.
indicator flashes green after releasing
indicator and indicator light green.
79