Panasonic KX-TG7893AZ Operating Instructions Manual page 68

DECT repeater
indicator
Status Meaning
Green Signal strength of the base
(On) unit is strong.
Amber Signal strength of the base
(On) unit is weak.
Red Out of base unit range.
(On)
Off R The unit is not being used.
R The power is off.
Installation
1
Connect the unit.
R Use only the supplied Panasonic AC
adaptor PQLV219AL.
Press plug firmly.
(220-240 V AC, 50/60 Hz)
R When the unit is turned on, the
indicator and
for about 2 seconds.
2
Confirm that the
indicator light green. (The unit is ready
for use.)
R If the indicators do not light green,
re-position the unit in a place where
the indicators light green.
Note:
R The AC adaptor must remain connected at
all times. (It is normal for the adaptor to feel
warm during use.)
R The AC adaptor should be connected to a
vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a
ceiling-mounted AC outlet, as the weight of
68
Hook
indicator light amber
indicator and
the adaptor may cause it to become
disconnected.
R The unit can support a maximum of 3
handsets at a time.
Setting the repeater mode
This repeater is pre-registered to the base unit
and the default setting of repeater mode is
"On". You do not need to change this setting
for initial use.
1
MMENUN #138
2
MbN: Select the desired setting. a
MSAVEN a MOFFN
Note:
R After turning the repeater mode on or off,
is displayed on the handset
momentarily. This is normal and the
handset can be used once
Wall mounting
Note:
R Make sure that the wall and the fixing
method are strong enough to support the
weight of the unit.
R Drive the screws (not supplied) into the wall.
Wall mounting template
37 mm
is displayed.
Screws
37 mm