NEC Express5800/R320a-E4 User Manual page 175

5.
After the system update is completed, the dialog box below will be displayed. Click [OK].
The system will be rebooted. Eject the DVD from optical disk drive after the reboot process
starts.
IMPORTANT:
If the message, "Windows - FT Orphaning A disk that is part of a fault-tolerant volume
can no longer be accessed" is displayed during the update process, an OS stop error may
occur when restarting the OS. If an OS stop error occurs, Hold down the POWER switch,
and turn off the system. In this case, the system will be successfully updated, however,
disk mirroring is disabled. Make sure to check disk mirroring in 8.
When "Found New Hardware" wizard appears at the reboot, click [Cancel]. If the same
message appears again, click [Cancel] again.
6.
Check disk mirroring.
If the disk mirroring is disabled, enable the mirroring again. For the method to check disk
mirroring, see "Step 8: Set Dual Disk Configuration" in Chapter 4.
IMPORTANT:
During disk re-synchronization, do not shut down the system until the resynchronization
is completed.
If the following dialog appears, confirm that the disk is mirrored and click [Yes] to restart
the system.
7.
Reboot the system.
8. After the system has rebooted, log on as a user with Administrative account.
IMPORTANT:
Check that the dual system is configured properly (confirm that the STATUS LED
illuminates green. See page 4-9 for location of the STATUS LED).
Troubleshooting 6-13