NEC Express5800/R320a-E4 User Manual page 150

5-6 Procedures after Completion of Installation
5. Click the [Add...] button in [Trap destinations]. After entering the IP address of the NEC
ESMPRO Manager machine of the send destination in the [Host name, IP or IPX address]
box, click the [Add] button.
IMPORTANT:
If you specify the same IP address (or host name) specified on the trap destination
also for the Manager Alert (TCP/IO) setting, a warning message appears to
indicate redundancy. With this configuration, the alert is redundantly sent to NEC
ESMPRO Manager of a specified IP address (or host name).
6. Open the [Security] property sheet and make settings as follows;
•
Add the community name entered in Step 4 to [Accepted community names].
•
Set its authority to [READ CREATE] or [READ WRITE].
•
Select [Accept SNMP packets from any host.]
IMPORTANT:
If you entered any community name other than "public" in Step 4, add that
name to "Accepted community names."
If you do not set the authority of [Accepted community names] as "READ
CREATE" or "READ WRITE", you cannot perform configuration or
monitoring from NEC ESMPRO Manager.
Setup of receiving SNMP packets from specific hosts only
Select [Accept SNMP packets from these hosts], specify IP addresses of the hosts, IP
addresses of the servers to install NEC ESMPRO Agent, and the loop-back address
(127.0.0.1).
Setup of receiving SNMP packets from specific communities only
Change the name of the community receiving SNMP packets from the default "public"
to any name.
IMPORTANT:
If the community name is changed, the community of NEC ESMPRO
Agent is changed and registered by starting from [Control Panel]. To
change the community to another and register it, use the [SNMP
Community] list box in the [General] tab.
To allow NEC ESMPRO Agent to receive SNMP packets sent from NEC
ESMPRO Manager, set the send community name in NEC ESMPRO
Manager to be the same as that accepted by the SNMP Service in NEC
ESMPRO Agent.