Vf-S11 Communication Parameters - Toshiba DEV001Z Function Manual

2.4. VF-S11 communication parameters

In a network, VF-S11 (DEV001Z) serves as a DeviceNet slave device. The DEV001Z
configuration is set by the following parameters.
The supported parameters for each drive and their allowable adjustment ranges are
defined in the appropriate Electronic Data Sheet (EDS) files. EDS files can be downloaded
via the internet from
http://www.inverter.co.jp/product/inv/vfs11/dev/
Parameter Function
f800
Communication
f803 Communication
error trip time
f890
f891 DeviceNet
Communication
f892 Communications
Loss action
(Network wire breaks)
f893 Preset speed No.
f894 Assembly
*1 Parameter f800 is VF-S11 internal communication speed. It is recommended that
the "4" is set to f800 for getting faster response.
*2 For safty, set the communication error trip time (f803).
*3 When out of range values are set up, the MS (Module Status) LED and will flash green
continuously to indicate an invalid set-up. DeviceNet communication is not possible in
this state.
*4 When the parameters are changed, the power must be cycled to the VF-S11 for the
changes to take effect.
RJ45 0: 1200bps
1: 2400bps
speed 2: 4800bps
3: 9600bps
4: 19200bps
0: Disabled
1- 100 (s)
MAC ID 0 - 63
0: 125kbps
1: 250kbps
speed 2: 500kbps
0: Stop, Communication
1: No action
2: Deceleration stop
3: Coast stop
4: Emergency stop
5: Preset speed command
(Preset speed by f893 setting）
0: No action
1-15: Preset speed
0: Instance 20/70
1: Instance 21/71
Object
2: Instance 100/150
3: Instance 101/151
Adjustment range
release
- 6 -
E6581268 ①
Shipment
3
0
0
0
0
0
0