4. Parameters
4.1. Communication parameters
Set up the inverter parameters as follows. These parameters do not take effect until the
inverter is reset. If these parameters are not set to correct value, this unit can not work
normally.
And configure the option with EDS file. The EDS file can be downloaded from the
following web site.
http://www.inverter.co.jp/product/inv/vfas1/ipe/index_i.htm
Communi
Title
cation No.
f821
0821
f822
0822
f823
0823
f792-
0792-
f799
0799
f576
0576
f577-
0577-
f580
0580
f581-
0581-
f584
0584
f585-
0585-
f588
0588
•If the address has been given by a BOOTP or a DHCP server, these fields (IP address IP Mask IP Gate) are read only.
•If you enter a value other than [0.0.0.0] (0) (0) (0) (0), dynamic addressing by a BOOTP or DHCP server is disabled.
•After dynamic addressing by a BOOTP or DHCP server, the new address value is displayed.
f784-
0784-
f789
0789
Function
Rate Setting (*1)
Actual Rate (L port)
Actual Rate (R port)
DEVICE NAME (*1)
IP mode (*1)
IP address (*1)
IP Mask (*1)
IP Gate (*1)
MAC address
Description
This field is used to set the transmission speed and the
transmission mode of the card.
0:Autodetect(default)
1:10Mbps Full
2:10Mbps Half
3:100Mbps Full
4:100Mbps Half
This field displays the baud rate and the transmission
mode currently used by the communication card.
(Display only)
0:unconnected
1:10Mbps Full
2:10Mbps Half
3:100Mbps Full
4:100Mbps Half
16 characters by a hex digit
0h to FFFFh for each of fields.
(There are 2 characters per one parameter.)
The device name is required if the card uses DHCP to
obtain its IP Address.
Use this parameter to select the IP address assignment
method.
0:Manual
1:BOOTP
2:DHCP
IP address of the card
0 to 255 for each of fields.
These fields are editable when IP mode = 0.
Subnet mask of the card
0 to 255 for each of fields.
These fields are editable when IP mode = 0.
Gateway IP address of the card
0 to 255 for each of fields.
These fields are editable when IP mode = 0.
MAC address display
0 to 255 for each of fields.
- 10 -
E6581580
Factory
setting
0
-
0,0,0,0
0,0,0,0
(HEX)
(*2)
0
0,0,0,0
0,0,0,0
0,0,0,0
-