Table of Contents
Advertisement
3. Installing the DEV002Z
Install the DeviceNet
* When this option is used together with the IO card option, attach this option to the front
panel side.
(1) Turn off input power of VF-AS1/PS1 and wait for at least 15 minutes and then check
(2) Securing the option to the inverter
* When installing this option to below capacities,
remove the Add-on type option case.
VFAS1: 200V 55, 75kW
400V 90 - 500kW
VFPS1: 200V 55 - 90kW
400V 90 - 630kW
b)
LED name label
MNS
MNS
MNS
MNS
MNS
option
that the CHARGE lamp on VF-AS1/PS1 is no longer lit.
a) Insert a flat-blade screwdriver in each of the two holes at the upper part of the front
panel, release the panel mounting tab by pushing the screwdriver down, and
remove the front panel cover.
b) Install the
in the inverter by fitting the tabs on the lower side of the
option
the slots at the lower part of the inverter front panel.
c) Make sure the option is securely attached to the inverter. Then, check whether the
plastic bosses on the inverter case have fitted in the holes at the upper and lower
parts of the
.
option
d) Insert the tabs at the lower part of the front cover into the slots at the lower part of
the inverter to attach the front cover to the inverter.
e) Stuck the enclosed "LED name label" on the option LED display part of a front
cover.
a)
c)
e)
to VF-AS1/PS1 as follows:
- 9 -
E6581295⑥
option
d)
into
Advertisement
Table of Contents
