Safety Precautions - Pakedge WX-1-O User Manual

2. Installation location
The product shall be installed at a location where the radiating antenna can be kept 22cm from nearby
person in normal operation condition to meet regulatory RF exposure requirement.
3. External antenna
Use only the antennas which have been approved by the applicant. The non-approved antenna(s) may
produce unwanted spurious or excessive RF transmitting power which may lead to the violation of FCC
limit and is prohibited.
4. Installation procedure
Please refer to user's manual for the detail.
5. Warning
Please carefully select the installation position and make sure that the final output power does not exceed
the limit set force in relevant rules. The violation of the rule could lead to serious federal penalty.

Safety Precautions:

•
Suitable for use in environmental air space in accordance with Section 300.22.C of National
Electrical Code, and Sections 2-128, 12-010(3) and 12-100 of the Canadian Electrical Code, Part 1,
C22.1. (Marking or Instruction)
•
The equipment is to be connected only to PoE networks without routing to the outside plant. Or
equivalent.
•
When using this device, always follow basic safety precautions, to reduce the risk of fire, electric
shock, and injury to persons, including the following:
•
Read all of the instructions (listed here and/or in the user manual) before you operate this
equipment.
•
Comply with all warning and caution statements in the instructions.
•
Retain the instructions for future reference.
•
Observe all warning and caution symbols that are affixed to this equipment.
•
Comply with all instructions that accompany this equipment.
•
Upon completion of any service or repairs to this product, ask the service technician to perform
safety checks to determine that the product is in safe operating condition.
WX-1-O User Guide Version 1.0