Table of Contents
Advertisement
Installation -
Disassemble the camera
Before installing your camera, you have to read the following cautions.
2. Don't let the cable to be caught in improper place or the electric line cover to be damaged. Otherwise
3. When installing your camera, don't allow any person to approach the installation site. If you have any
valuable things under the place, move them away.
LED ON/OFF
Reset Button
1
Detach the dome cover by torx wrench provided from
bottom case before installation the camera.
Match the one screw hole on the dome cover and
camera bottom specially.
Reset to the Factory Default
Press the reset button for 5 seconds to return the setup
to the factory default.
Warning:
If you press the 'Reset' button, you will lose all setting
data. If needed, please, make a note for further installation.
2
The camera has a manual IR switch, located under
the camera's lens. You can use this switch to
manually turn the IR LED board on or off according to
the installation needs.
Advertisement
Table of Contents
