Step 3. Preparing Unit For Installation; Step 4 Install Anti-Tip Bracket - Monogram ZIRNPKII Installation Instructions Manual

Installation Instructions - Single Integrated Installation
STEP 3 PREPARING UNIT FOR
INSTALLATION
Place the unit in front of the installation opening in a
way that the unit is in front of the intended installed
location.
If the door will be reversed after installing, the
stabilization bracket at the top hinge side of the case
will need to be moved to the opposite side of the
case. Remove 4 Phillips head screws, rotate the
stabilization bracket and install on the opposite side
of the case.

STEP 4 INSTALL ANTI-TIP BRACKET

WARNING
This appliance is top heavy, especially with any
doors open, and must be secured to prevent tipping
forward which could result in death or serious injury.
Read and follow the entire installation instructions
for securing the appliance with the anti-tip system.
Remove the anti-tip bracket from the hardware kit.
Anti-tip bracket should be mounted against the back
wall or up to 27" (68.6 cm) maximum from front of
opening. Use floor mounting method if the bracket is
not against a wall (bracket hardware is provided for
mounting into wood, steel studs and concrete).
Unit From Enclosure
18" 10-7/8"
(27.62cm)
24" 14-7/8"
(37.78cm)
30" 18-7/8"
(47.95cm)
Measure and mark from the left side of the opening
per the table depending on the size of the unit you
are installing.
31-49133-1
Stabilization
Bracket
Tip Over Hazard.
STEP 4 INSTALL ANTI-TIP BRACKET
Mount the anti-tip bracket centered about the mark
and flush to the floor as shown. Mark 3 holes for wall
mounting or 4 holes for floor mounting.
WOOD MOUNTING: Predrill with 3/16" drill bit, 2"
deep, then install lag bolts with a 7/16" driver.
CONCRETE MOUNTING: Predrill with a 5/32"
concrete bit, 2" deep, then install tapcon screws with
a 7/16" driver.
STEEL MOUNTING: Predrill with a 1/2" drill bit, insert
toggle, then install bolts with a 7/16" driver.
The bracket must be screwed to either the FLOOR or
REAR WALL.
Tape the waterline to the wall and floor approximately
3" to the left of the anti-tip bracket. Apply tape about
every 5" toward the front of the opening (tape will
prevent the unit from rolling over the waterline during
installation). Do not tape near the cabinet front in
order to keep tape hidden under the unit.
Route the strapping coiled up at the back of the unit
through the anti tip bracket.
1. Cut the wire tie holding the strap bundle.
2. Put the strap on the backside of the retaining pin.
3. Secure the retaining pin to the bracket with the
cotter pin.
35
3"
5"
Cotter
Pin
Retaining
Pin