Installation Instructions; Step 1 Remove Packaging And Installation Parts; Step 2 Install Custom 3/4" Door Panel And Handle; (Zifi240 And Zibi240 Models Only) - Monogram ZIFI240 Installation Instructions Manual

STEP 1 REMOVE PACKAGING
AND INSTALLATION PARTS
• Remove corner blocks and foam drawer stops.
• Remove all packing material, tape and protective
plastic coverings.
• Remove the toekick attached to the back of the unit.
• Remove the custom panel attached to the front of
the unit.
CAUTION:
Small objects are a choke
hazard for children. Remove and discard any parts
not used.
ATTENTION :
étrangler les enfants. Il faut jeter toutes les pièces qui
ne sont pas utilisées.
STEP 2 INSTALL CUSTOM 3/4"
DOOR PANEL AND HANDLE

(ZIFI240 and ZIBI240 models only)

3/4" Overlay Panel Dimensions
Model ZIFI240 and ZIBI240
require a field-installed overlay
door panel.
• The overlay panel must be
secured to a 1/4" thick backer
panel that slides into the trim.
A .10" thick spacer panel must
be placed between the overlay
and backer panel.
• A custom handle of your choice,
supplied by your cabinetmaker, must be installed
on this overlay panel. Countersink all screws into
the backer panel. Screws cannot protrude from the
backer panel.
IMPORTANT NOTE: Maximum total weight for
custom door panel is 25 pounds.
3/4" Overlay Panel Dimensions (in inches)
1/4" Backer
B
0.10" Spacer
3/4" Overlay
A

Installation Instructions

Les petits objets peuvent
Overlay
Panel
Door
1/4"
.10 Inch
Backer
Spacer
Panel
A (Width) B (Height)
23-3/16" 29-9/16"
22-1/2" 29-1/16"
23-5/8" 30"
STEP 2 INSTALL CUSTOM 3/4" DOOR
PANEL AND HANDLE
(ZIFI240 and ZIBI240 models only)
Assemble overlay panels
with glue and screws.
• Center spacer panel on the
backer panel, left to right and
top to bottom. Secure the
panels with glue.
• Center the spacer/backer
panel on the overlay panel.
Secure with glue and screws. Countersink all screws
into the backer panel.
Custom Panel Hinge Routing Dimensions
Use a 3/4" router bit to cut a notch into the back side
of the assembled panel 3/8" toward the front of the
overlay panel, 3/4" deep and 7/8" wide.
7/8"
3/8"
7/8"
3/8"
Install custom door panel and handle:
• Open door to 90°.
• Remove 5 screws holding trim; lift off trim.
Retain screws.
6
(CONT.)
Overlay Panel
Spacer Panel
Backer Panel
3/4"
Back side of
custom panel
3/4"