Table of Contents
Advertisement
Installation Instructions - Dual Integrated Installation
STEP 3 PREPARING UNIT FOR INSTALLATION
Place the right hand unit in front of the installation
opening in a way that the unit is in front of the intended
installed location.
If doors will be reversed after installing, the stabilization
bracket at the top hinge side of the case will need to
be moved to the opposite side of the case. Remove 4
Phillips head screws, rotate the stabilization bracket
and install on the opposite side of the case.
Unpack the heater Unification Kit (ZUGC) and make
sure all of the components on the list are included.
Install 4 bumper blocks by snapping them to the left
side of the case between the 2 units - 2 on the upper
section of the case wall and 2 on the lower.
Lower bumpers
Stabilization
Bracket
Upper bumpers
Install adhesive heater on the outside of the unit to
the left side of the case. Install heater 2" below the top
2 standoff blocks. Heater should be centered front to
back on the metal case. Ensure the heater connector
cord is toward the bottom of the unit when installed.
Clips
Hex
Screws
Remove the left access cover by removing 4 (1/4") hex
screws. The cover is located at the outside lower left
side of the case.
Use clips to adhere loose wire tightly to side of case as
shown. Clean the side using rubbing alcohol to ensure
proper clip adhesion.
10
Adhesive
Heater
Left Access
Cover
31-49133-1
Advertisement
Table of Contents
