Monogram ZIRNPKII Installation Instructions Manual page 50

Installation Instructions - Stainless Door Panel
STEP 5 INSTALL DOOR TRIMS
(Cont.)
Without touching the exposed tape to the side of the
door, align the top of the trim with the top of the door
panel. (tape backer should be sticking out
when aligning the trim).
Once the trim is in location
(aligned to the top of the door,
hinge covers, tight to the door
and door panel), then push
on the exposed tape area to
secure. Slowly start pulling the
tape backer off and pushing to
adhere the tape while keeping
the trim in place until you have
completely removed the tape
backing.
Secure the top and bottom
portions of the outer trim
after the inner trim has been
secured.
1. Gently pull the top of the
outer trim away from the door panel in order to
expose the tape backer. Do not bend too far away
from the door or trim damage may occur.
2. Peel the backer off the outer trim tape and press
to secure the trim.
3. Repeat for the bottom of the outer trim.
Once the handle side door trim is in place, repeat the
same steps for the hinge side door trim.
50
31-49133-1