Monogram ZIRNPKII Installation Instructions Manual page 25

Installation Instructions - Dual Retro-Fit Installation
STEP 5 JOINING DUAL INSTALLED UNITS (Cont.)
CHANGE POWER CORD
Longer power cords are required for retro fit installation.
Power cords are included in 42" ZTKC42 and 48"
ZTKC48.
Replace power cords on both units. Both units can be
plugged into the same electrical supply receptacle.
Remove existing short power cord with string
assembly:
Remove 1/4" hex screws attaching rear access cover.
1. Unplug 3-pin power cord connector inside the
machine compartment (press on sides to release
locking tabs).
2. Remove power cord green ground 1/4" hex screw.
3. Remove strain relief 1/4" hex screw.
Strain Relief
Screw
Install new longer power cord:
1. Plug in the 3-pin connector (make sure locking tabs
are engaged).
2. Install the power cord green ground screw.
3. Install the power cord strain relief.
Replace rear access cover. Make sure the power
cord and ground wire are properly routed through the
access cover cut-out.
Repeat all steps for second unit.
31-49133-1
3-Pin
Power Cord
Green Connector
Ground
Screw
Rear
Access
Cover
Ground
Wire
Power
Cord
CASE TRIM INSTALLATION
Remove the stabilization brackets from the hinge side
of each column refrigerator by removing 4 Phillips head
screws per bracket.
Install the trim kit side rails to the exposed right and left
case walls using the provided #8 Phillips head screws -
7 screws per side.
Power
Cord
Pre-assemble the trim kit top rail and corner keys.
One corner key should be installed to each end of the
top trim. Use the provided 5/64" allen set screw in the
corner key to ensure that the key is snuggly fit to the
top trim, but be sure not to overtighten the screw to
prevent damage to the parts.
25
Stabilization
Bracket
Corner
Key