Step 3 Move Control Assembly; Step 4. Hove Light Switch Housing - Monogram ZIRNPKII Installation Instructions Manual

Installation Instructions - Reversing the Door Swing

STEP 3 MOVE CONTROL ASSEMBLY

Remove the Phillips head screw from the middle of
the housing on the hinge side.
Screw
Insert a flat head screwdriver or putty knife between
the glass front and plastic side and free the control
assembly by prying the plastic pins clear of the side
bracket holes.
Lay the glass assembly on top of the control housing.
Remove 4 screws, 2 on each end, to remove the
housing assembly using a T-20 Torx bit.
Move the housing assembly to the opposite side and
install using the 4 screws, 2 on each side.
NOTE: Make sure
wires do not get
pinched. On 18"
models, the red/
white/black 5-pin
wire connector
will need to be
removed from the
control board and
routed through
the opposite corner bracket and reconnected to the
control board to prevent pinching the wiring.
Snap glass assembly back onto the control housing
assembly, ensuring plastic pins snap into holes on
the side of the housing.
Reinstall the screw into the housing on the new
hinge side.
Plastic Pins
(Both sides)
5-pin wire connector
Wires must be rerouted from one
side to the other for 18" models.
STEP 4 MOVE LIGHT SWITCH
HOUSING
Remove front access cover from unit by removing 2
T20 Torx screws (if not already removed)
Front Access
Cover
Turn off master switch
Remove screw with T-20 Torx bit at the bottom
middle of light switch housing.
Light Switch
Housing
Slide housing forward and down to remove from case
and grommets on case bottom.
Keeping it connected to the unit, lay housing aside.
Remove 2 grommets with Phillips driver.
Move grommets to the set of 2 holes on opposite
side.
42
T20 Torx Screws
Grommets
Master
Switch
31-49133-1