Table of Contents
Advertisement
Chapter 6
•
Enable Short GI
- It is recommended to enable this function, for it will increase the
data capacity by reducing the guard interval time.
•
Enable AP Isolation
wireless stations cannot access each other through WLAN. This function will be
disabled if WDS/Bridge is enabled.
6. 4. 6.
Wireless Statistics
1. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2. Go to
Setting
>
and received by each client device connected to the router.
•
MAC Address
- The MAC address of the connected wireless client.
•
Current Status
- The running status of the connected wireless client.
•
Received Packets
•
Sent Packets
- Packets sent by the wireless client.
•
Configure
- The button is used for loading the item to the Wireless MAC Filtering list.
•
Allow
- If the Wireless MAC Filtering function is enabled, click this button to
allow the client to access your network.
•
Deny
- If the Wireless MAC Filtering function is enabled, click this button to
deny the client to access your network.
6. 5.
DHCP
By default, the DHCP (Dynamic Host Configuration Protocol) Server is enabled and the
router acts as a DHCP server; it dynamically assigns TCP/IP parameters to client devices
from the IP Address Pool. You can change the settings of DHCP Server if necessary, and
you can reserve LAN IP addresses for specified client devices.
- This function isolates all connected wireless stations so that
Wireless 2.4GHz
>
Wireless Statistics
- Packets received by the wireless client.
Configure the Router in Access Point Mode
to check the data packets sent
169
Advertisement
Table of Contents
