Transferring Data - Emerson Unidrive HS72 Control Getting Started Manual
Universal variable speed ac drive for induction and permanent magnet motors
Hide thumbs
Also See for Unidrive HS72:
- Installation manual (102 pages) ,
- Installation manual (120 pages)
Table of Contents
Advertisement
4.14
Transferring data
Data transfer, erasing and protecting the information is performed by entering a code in Pr mm.000
and then resetting the drive as shown in Table 4-4.
Table 4-4 SMARTCARD and SD card codes
Code
Transfer the drive parameters to parameter file 001 and
2001
sets the block as bootable. This will include the parameters
from attached option modules.
Transfer the drive parameters to parameter file yyy. This
4yyy
will include the parameters from attached option modules.
Transfer the onboard user program to onboard user
5yyy
program file yyy.
Load the drive parameters from parameter file yyy or the
6yyy
onboard user program from onboard user program file yyy.
7yyy
Erase file yyy.
Compare the data in the drive with file yyy. If the files are
the same then Pr mm.000 (mm.000) is simply reset to 0
8yyy
when the compare is complete. If the files are different a
'Card Compare' trip is initiated. All other NV media card
trips also apply.
9555
Clear the warning suppression flag
9666
Set the warning suppression flag
9777
Clear the read-only flag
9888
Set the read-only flag
9999
Erase and format the NV media card
Transfer a program from an option module in slot 1 to an
15yyy
option module applications file
16yyy
As 15yyy, but for slot 2
17yyy
As 15yyy, but for slot 3
Load a program to the option module in slot 1 from an
18yyy
option module applications file
19yyy
As 18yyy, but for slot 2
20yyy
As 18yyy, but for slot 3
21yyy
As 15yyy, but for slot 4
22yyy
As 18yyy, but for slot 4
Backup all drive data (parameter differences from defaults,
an onboard user program, applications programs and
miscellaneous option data), including the drive name; the
40yyy
store will occur to the </MCDF/driveyyy/> folder; if it does
not exist, it will be created. Because the name is stored, this
is a backup, rather than a clone. The command code will be
cleared when all drive and option data have been saved.
Load all drive data (parameter differences from defaults, an
onboard user program, applications programs and
miscellaneous option data); the load will come from the
60yyy
</MCDF/driveyyy/> folder. The command code will not be
cleared until the drive and all option data have been
loaded.
Unidrive M702 / HS72 Control Getting Started Guide
Issue Number: 2
Operation
SMARTCARD
SD card
23
Advertisement
Table of Contents
