Menu 0; Menu Structure - Emerson Unidrive HS72 Control Getting Started Manual

Figure 4-3 Mode examples
1
Do not change parameter values without careful consideration; incorrect values may
cause damage or a safety hazard.
WARNING
When changing the values of parameters, make a note of the new values in case they
NOTE
need to be entered again.
For new parameter-values to apply after the AC supply to the drive is interrupted, new
NOTE
values must be saved. Refer to section 4.8 Saving parameters on page 19.
4.4

Menu 0

Menu 0 is used to bring together various commonly used parameters for basic easy set up of the
drive. Appropriate parameters are copied from the advanced menus into menu 0 and thus exist in
both locations. For further information, refer to Chapter 5 Basic parameters (Menu 0) on page 24.
4.5

Menu structure

The drive parameter structure consists of menus and parameters. The drive initially powers up so
that only Menu 0 can be viewed. The up and down arrow buttons are used to navigate between
parameters and once Pr 00.049 has been set to 'All Menus' the left and right buttons are used to
navigate between menus. For further information, refer to section 4.12 Parameter access level and
security on page 20.
Figure 4-4 Menu structure
Menu 0
....MM.000....
00.050
00.049
00.048
00.047
00.046
00.005
00.004
00.003
00.002
00.001
Moves between Menus
Unidrive M702 / HS72 Control Getting Started Guide
Issue Number: 2
2
The menus and parameters roll over in both
directions. i.e. if the last parameter is
displayed, a further press will cause the
display to rollover and show the first
parameter.
When changing between menus the drive
remembers which parameter was last
viewed in a particular menu and thus
Moves
displays that parameter.
between
parameters
* The option module menus (S.mm.ppp) are
only displayed if option modules are
installed. Where S signifies the option
module slot number and the mm.ppp
signifies the menu and the parameter
number of the option module's internal
menus and parameter.
3 4
17