Gree SAP09HP230V1AH Service Manual page 67

Timer range: 0.5-24hr. Every press of ▲or ▼ will make the set time increased or decreased by 0.5hr. If either of them is pressed
continuously, the set time will increase/ decrease by 0.5hr every 0.5s.
3.6 Swing Setting
Swing On: Press Function under on state of the unit to activate the swing function. In this case,
to make a confirmation.
Swing Off: When the Swing function is on, press Function to enter the Swing setting interface,with
Cancel to cancel this function. Swing setting is shown as Fig.3.6.1.
Turn off the unit,without Swing
function activated
Fig.3.6.1 Swing Setting
Notes:
(1)Sleep, Turbo or Blow setting is the same as the Swing setting.
(2)After the setting has been done, it has to press the key "Enter/Cancel" to back to the setting status or quit automatically five seconds
later.
3.7 Sleep Setting
Sleep on: Press Function under the On state of the unit till the unit enters the Sleep setting state. After that, press Enter/Cancel to
confirm this setting.
Sleep off: When the Sleep function is activated, press Function to enter the Sleep setting status. After that, press Enter/Cancel to cancel
this function.
In the Cooling or Dry mode, the temperature will increase by 1°C(1~2°F) after the unit runs under Sleep1 for 1hr and 1°C(1~2°F) after
another 1hr.After that, the unit will run at this temperature.
In the Heating mode, the temperature will decrease by 1°C(1~2°F) after the unit runs under Sleep 1 for 1hr and 1°C(1~2°F) after another
1hr. After that, the unit will run at this temperature.
64
Press Function repeatedly unitll
go to the Swing setting status
Press Enter/Cancel to cancel this
setting
will blink,After that,press Enter/Cancel
blinking. After that, press Enter/
Press Enter/Cancel to activated the Swing
function
Press Function repeatedly unitll go to the
Swing function again
Installation and Maintenance
Service Manual