Arctic Cat Y-12 2008 Manual page 85

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
4. Remove the drive chain master link clip, link
plate, and master link; then allow the drive chain
to roll off the rear sprocket. Account for four
O-rings on the master link.
NOTE: It is not necessary to completely remove
the drive chain in order to remove the rear sprocket.
5. Slide the right-side axle spacer off the axle.
6. Remove the two cap screws securing the chain
guard to the axle housing.
7. Slide the rear sprocket carrier and rear sprocket
off the axle.
www.mymowerparts.com
Back
6-6
MD2363
KM238A
MD2365
Back to TOC
8. Remove three cap screws securing the sprocket
to the sprocket carrier; then remove the
sprocket.
INSTALLING REAR SPROCKET
1. Position the sprocket onto the sprocket carrier;
then install the three cap screws securing the
sprocket to the sprocket carrier. Tighten the cap
screws to specifications.
2. Slide the rear sprocket carrier and rear sprocket
onto the axle and into position next to the axle
housing.
3. Slide the right-side axle spacer onto the axle.
4. Install the drive chain (see Installing Drive
Chain in this sub-section).
5. Install the chain guard and secure with two cap
screws. Tighten securely.
6. Install the right rear wheel and hub as a unit.
7. Install the washer and castle nut. Tighten the
castle nut to specifications.
Back to Section TOC
MD2368
MD2369
Next