Disassembly Instructions - Mitsubishi Electric MUZ-HJ25VA-E2 Service Manual

12

DISASSEMBLY INSTRUCTIONS

<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are 2 types (refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
12-1. MUZ-HJ25VA MUZ-HJ35VA
OPERATING PROCEDURE
1. Removing the cabinet and the panels
(1) Remove the screws fixing the service panel.
(2) Pull down the service panel and remove it.
(3) Disconnect the power supply and indoor/outdoor con-
necting wire.
(4) Remove the screws fixing the top panel.
(5) Remove the top panel.
(6) Remove the screws fixing the cabinet and the motor
support.
(7) Remove the cabinet.
(8) Remove the fixing screws of the terminal block support
and the back panel. (Photo 4)
(9) Remove the screws fixing the back panel.
(10) Remove the back panel.
Photo 2
Screw of the cabinet
OBH648F
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Screws of
the top panel
Direction to
remove
Screws of
the service panel
Hooks
56
(2) The terminal with this connector has the
locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
NOTE: Turn OFF the power supply before disassembly.
PHOTOS
Photo 1
Screws of
the top panel
Screws of the cabinet
Photo 3
Screws of
the back panel
Screws of the
motor support