Emerson IDEAL CF330BQ00 Owner's Manual page 9

3. Ceiling Fan Assembly
3.11
Route the two 80" Motor Wires through the Hanger Ball
(Figure 11).
Reinstall the Hanger Ball on the Downrod as follows:
Position the Pin through the two holes in the Downrod
and align the Hanger Ball so the Pin is captured in the
groove in the top of the Hanger Ball (Figure 11).
Pull the Hanger Ball up tight against the Pin and
securely tighten the Phillips Set Screw in the Hanger
Ball (Figure 11).
Loose set screw could create fan wobble.
3.12
The fan comes with Black and White Wires that are
80-inches long.
Measure up approximately 6 to 9-inches above top of
Hanger Ball / 4.5" Downrod Assembly (Figure 12).
Cut off excess wires and strip back insulation 1/2-inch
from end of wires.
You have now partially completed the assembly of your
new ceiling fan, proceed to How to Hang Your Ceiling
Fan. Final Assembly of the ceiling fan will be completed
once ceiling fan is hung and wired.
(Continued)
DOWNROD
PHILLIPS HEAD
SET SCREW
Figure 11
1/2-INCH
6 TO 9
INCHES
Figure 12
9
PIN
HANGER BALL
BLACK WIRE
WHITE WIRE
HANGER BALL
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF330