Table of Contents
Advertisement
Troubleshooting
Check
Are signals being received within the Wire-
lessHD transmission range?
Is the supplied WirelessHD Transmitter
turned on?
Is the WiHD indicator for the supplied Wire-
lessHD Transmitter off?
Is the Link indicator for the supplied Wire-
lessHD Transmitter off?
Has dust collected in the WirelessHD's air in-
take vent?
Are the projector and the WirelessHD Trans-
mitter facing the correct way?
Is "Source: WirelessHD X"/"No Signal" dis-
played in the lower-left part of the screen?
Interference, distortion, or interruption appear in WirelessHD
Check
Are signals being received within the Wire-
lessHD transmission range?
Are there any obstructions between the Wire-
lessHD Transmitter and the projector?
Is the reception too low?
Check the Wireless HD transmission range, and view within that
range.
p.74
s
Check the
indicator on the WirelessHD Transmitter. If there is
t
no power being supplied, make sure the connector for the AC
adapter is securely connected, and then turn on the power
switch.
No signal is output from the AV device connected to the Wire-
lessHD Transmitter. Check that the cables from the AV device and
the WirelessHD Transmitter are securely connected.
Images are being output from a monitor device, such as a tele-
vision, connected to the Output port on the WirelessHD Trans-
mitter. Press the
to the projector.
The WirelessHD cannot communicate with the projector. Check
the Wireless HD transmission range, and view within that range.
If the WirelessHD receiver becomes hot, it may not receive sig-
nals. Clean the dust so that heat can be vented.
Setup the projector and the WirelessHD Transmitter so that they
are facing each other.
Check that the AV device connected with the HDMI port on the
WirelessHD Transmitter is turned on. The input signal number
displayed on the screen is the same as the HDMI port number.
In addition, unless HDMI Link is set to On, the connected device
does not turn on. Set HDMI Link to On.
Link - HDMI Link
p.91
Check the Wireless HD transmission range, and view within that
range.
p.74
s
Because WirelessHD communicates using a tight beamed elec-
tromagnetic wave, if there are any people or objects and so on
obstructing the communication path, this could have an adverse
affect on the image. Make sure that there are no obstacles be-
tween the WirelessHD Transmitter and the projector within the
WirelessHD transmission range.
If the transmissions are not strong enough, communication may
be unstable.
Check Reception while images are being projected as you set
up the transmitter as it is sometimes possible to improve the
strength of the transmission by moving the WirelessHD Trans-
mitter or changing its direction.
Reception
p.91
Transmission strength may differ depending on the surround-
ings, or they may be unstable. While checking Reception, setup
the transmitter in a location where the number displayed re-
mains steady.
Settings - WirelessHD - Reception
s
112
Remedy
button and change the output image
Settings - HDMI
s
Remedy
p.74
s
Settings - WirelessHD -
s
p.91
Advertisement
Table of Contents
