Epson EH-LS9600e User Manual page 48

Setting Image Quality
a
Press the
c
•
You can make settings from the Configuration menu.
•
This cannot be set when a computer image signal is being input.
•
This cannot be set when converting 2D images to 3D images.
Conversion
•
How the image is viewed may change depending on the temperature of the surroundings. It is
recommended that you leave the projector on for a while before performing operations.
b
Use the
the selection.
Select 1 to 5 when setting the super-resolution.
Select 4K-1 to 4K-5 when projecting 4K images and setting super-resolution.
The higher the item number, the stronger the effect.
c
•
Depending on the image, distortion at the edge of the image may be enhanced. If you notice
any distortion, set another item.
•
4K Enhancement cannot be set when projecting 3D images. Super-resolution is enabled only
for 1080p/24 Hz/frame packing signals.
•
1 to 5 cannot be set when a 4K image signal is being input.
•
4K-1 to 4K-5 cannot be selected when Image Processing is set to Fast. Set Fine.
Advanced - Image Processing
c
Press the
c
The following restrictions apply when projecting a 4K image.
- Aspect: Only Normal, Anamorphic Wide, and Horiz. Squeeze are available
- Frame Interpolation: Only available when a 1080p/24 Hz signal is input, and fixed at Off when
other signals are being input
- Image Processing: Fixed at Fine
button.
p.88
buttons to select the item, and then press the
p.88
button to exit the menu.
Signal - Super-resolution/4K
s
s
47
Signal - 3D Setup - 2D-to-3D
button to confirm
Signal -
s
p.88