Supermicro SuperServer 6048R-TXR User Manual page 62

S S
UPER ERVER 6048R-TXR User's Manual
NIC1/NIC2 LED Indicators
The NIC (Network Interface Controller)
LED connection for GLAN port 1 is
located on pins 11 and 12 of JF1, and
the LED connection for GLAN Port 2 is
on Pins 9 and 10. Attach the NIC LED
cables here to display network activity.
Refer to the table on the right for pin
definitions.
Overheat (OH)/Fan Fail/PWR Fail/
UID LED
Connect an LED cable to pins 7 and
8 of Front Control Panel to use the
Overheat/Fan Fail/Power Fail and UID
LED connections. The red LED on pin
8 provides warnings of overheat, fan
failure or power failure. The blue LED
on pin 7 works as the front panel UID
LED indicator. Refer to the table on
the right for pin definitions.
Power Fail LED
The Power Fail LED connection
is located on pins 5 and 6 of JF1.
Refer to the table on the right for pin
definitions.
Reset Button
The Reset Button connection is located
on pins 3 and 4 of JF1. Attach it to a
hardware reset switch on the computer
case. Refer to the table on the right for
pin definitions.
Pin Definitions (JF1)
Pin#
9
10
11
12
OH/Fan Fail/ PWR Fail/Blue_UID
LED Pin Definitions (JF1)
Pin# Definition
7 Blue_UID LED
8 OH/Fan Fail/Power Fail
OH/Fan Fail/PWR Fail
LED Status (Red LED)
State
Off
On
Flashing
Pin Definitions (JF1)
Pin#
5
6
Pin Definitions (JF1)
Pin#
3
4
5-16
GLAN1/2 LED
Definition
Vcc
NIC 2 LED
Vcc
NIC 1 LED
Definition
Normal
Overheat
Fan Fail
PWR Fail LED
Definition
3.3V
PWR Supply Fail
Reset Button
Definition
Reset
Ground