Coban BN-311 User Manual page 32

No alarm
1. Authorized number has not been set up.
notification
2. The format of the phone number is incorrect.
message
1. Please check whether the engine stop wiring connected correctly?
2. Please check whether the speed is higher than the speed to
Fail to stop engine
Remote control
Turn off tracker, and turn it on to program the remote control again.
cannot be used
This tracker drives the speaker output voltage DC12V/24V/1A, if it is
Siren doesn't work
a negative trigger speaker, it will not be driven.
Manufacture： Shenzhen Coban Electronics Co.,LTD
Address:602 &702, Bldg. C2, Xinqiao Industrial Park, Tongfuyu Industrial Area, Xinhe Avenue, Gonghe
Community, Shajing Sub-District, Bao'an District, Shenzhen, Guangdong, Chin
FCC Warning
Any Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device m ay not caus e harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to pa rt 15 of the FCC Rules. T hese limits a re de signed to provide reasonable protection a gainst ha rmful
interference i n a r esidential installation. This equi pment ge nerates, uses and can radiate r adio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio c ommunications. H owever, there is no gua rantee that i nterference w ill not occur i n a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
—Reorient or relocate the receiving antenna.
32
execute the stop command when using Delay execution way?