Function Code 4: Force A Drive Dump; Function Code 5: Copy Drive Dump - IBM System Storage TS2250 Setup, Operator, And Service Manual

1. Place the drive in Maintenance Mode. For instructions, see "Entering
2. Press the Unload Button once per second until
3. Press and hold the Unload Button for three or more seconds, then release it to
4. Insert a scratch (blank) data cartridge that is not write protected (or the tape

Function Code 4: Force a Drive Dump

Function Code
also known as saving a microcode trace).
1. Place the drive in Maintenance Mode. For instructions, see "Entering
2. Press the Unload Button once per second until
3. Press and hold the Unload Button for three or more seconds, then release it to

Function Code 5: Copy Drive Dump

Function Code
to the beginning of a scratch (blank) data cartridge.
Attention: For this function, insert only a scratch (blank) data cartridge or a
cartridge that may be overwritten. During the test, the drive overwrites the data on
the cartridge.
Note: If you inserted an invalid tape cartridge (for example, Gen2 or WORM
3-12
TS2250 Tape Drive Setup, Operator and Service manual
Maintenance Mode" on page 3-9.
cycle past the desired code, press the Unload Button once per second until the
code reappears.)
select the function. The SCD changes to a flashing
drive exits maintenance mode). If the cartridge is not inserted within 60
seconds, the drive will exit Maintenance Mode. The SCD changes to a flashing
3
. The tape drive copies the FMR data to the scratch data cartridge.
v If the tape drive creates the FMR tape successfully, it rewinds and unloads
the new tape, exits Maintenance Mode, and the tape is ready to use .
v If the tape drive fails to create the FMR tape, it displays an error code. To
determine the error, see Error Codes and Messages. The tape drive then
unloads the FMR tape, and exits Maintenance Mode after the cartridge is
removed.
8
performs a dump of data collected by the drive (this process is
Maintenance Mode" on page 3-9.
cycle past the desired code, press the Unload Button once per second until the
code reappears.)
select the function. The drive performs the dump. The SCD shows
goes blank, and the drive exits Maintenance Mode. To access the contents of the
dump, see "Function Code 5: Copy Drive Dump."
Note: You can also force a drive dump when the tape drive is in normal
operating mode. Simply press and hold the Unload Button for ten
seconds. This causes the drive to reboot.
5
copies data from a drive dump (captured in Function Code 4)
J
media), error code
write-protected cartridge, or the media has read-only compatibility (for
3
8
7
or appears in the SCD. If you inserted a
appears in the SCD. (If you
C
.
appears in the SCD. (If you
0
, then