Table of Contents
Advertisement
Installation Instructions (Continued)
CAUTIONS
1.
The induction cooktop must be installed by qualified personnel or technicians. We have professionals at
your service. Please never conduct the operation by yourself.
2. The induction cooktop shall not be mounted to cooling equipment, dishwashers and rotary dryers.
3. The induction cooktop shall be installed such that better heat radiation can be ensured to enhance
its reliability.
4. The wall and induced heating zone above the work surface shall withstand heat.
5. To avoid any damage, the sandwich layer and adhesive must be resistant to heat.
6. A steam cleaner is not to be used.
ELECTRICAL CONNECTION
IMPORTANT
The cooktop must NOT be connected to the mains supply by means of a 10A or 15A plug and socket.
This cooktop must be connected to the mains power supply only by a suitably qualified person.
Before connecting the cooktop to the mains power supply, check that:
1.
The domestic wiring system is suitable for the power drawn by the cooktop.
2. The voltage corresponds to the value given in the rating plate
3. The power supply cable sections can withstand the load specified on the rating plate.
To connect the cooktop to the mains power supply, do not use adapters, reducers, or branching devices, as they can
cause overheating and fire.
The power supply cable must not touch any hot parts and must be positioned so that its
temperature will not exceed 75˚C at any point.
Check with an electrician whether the domestic wiring system is suitable without alterations. Any alterations must
only be made by a qualified electrician.
The power supply should be connected in compliance with the relevant standard, or a single-pole circuit
breaker. The method of connection is shown in the below wiring diagram.
WIRING DIAGRAM
WARNING
The bottom surface and the power cord of the cooktop are not accessible after installation.
•
If the cable is damaged or needs replacing, this should be done by an after-sales technician using the proper
tools, so as to avoid any accidents.
•
If the appliance is being connected directly to the mains supply, an omnipolar circuit breaker must be installed
with a minimum gap of 3mm between the contacts.
•
The installer must ensure that the correct electrical connection has been made and that it complies
with safety regulations.
•
The cable must not be bent or compressed.
•
The cable must be checked regularly and only replaced by a properly qualified person.
•
The installer must to use the H05GG-F power cord.
18
Advertisement
Table of Contents
