Inalto ICI30T.1 User Manual page 17

30cm induction cooktop
Hide thumbs Also See for ICI30T.1:
Table of Contents

Advertisement

BEFORE INSTALLING THE COOKTOP, ENSURE
The work surface is square and level, and no structural members interfere with space requirements.
The work surface is made of a heat-resistant and insulated material.
If the cooktop is installed above an oven, the oven has a built-in cooling fan.
The installation will comply with all clearance requirements and applicable standards and regulations.
A suitable isolating switch providing full disconnection from the mains power supply is incorporated in the
permanent wiring, mounted and positioned to comply with the local wiring rules and regulations.
The isolating switch must be of an approved type and provide a 3 mm air gap contact separation in all poles
(or in all active [phase] conductors if the local wiring rules allow for this variation of the requirements).
The isolating switch will be easily accessible to the customer with the cooktop installed.
You consult local building authorities and by-laws if in doubt regarding installation.
You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall surfaces surrounding
the cooktop.
AFTER INSTALLING THE COOKTOP, ENSURE
The power supply cable is not accessible through cupboard doors or drawers.
There is adequate flow of fresh air from outside the cabinetry to the base of the cooktop.
If the cooktop is installed above a drawer or cupboard space, a thermal protection barrier is installed below the
base of the cooktop.
The isolating switch is easily accessible by the customer.
ADJUSTING THE FIXING BRACKETS
The unit should be placed on a stable, smooth surface (use the packaging or a towel). Do not apply force onto the
controls protruding from the cooktop.
Fix the cooktop on the work surface by screwing four brackets to the bottom of cooktop after installation. Adjust the
bracket position to suit for different work surface's thickness.
WARNING
Under any circumstances, the brackets cannot touch with the inner surfaces of the worktop after installation
(see image above).
17

Advertisement

Table of Contents
loading

Table of Contents